Investigations on microstructural and mechanical properties of friction stir welded AA 2024-T351


KASMAN Ş., OZAN S.

MATERIALS TESTING, cilt.62, sa.8, ss.793-802, 2020 (SCI-Expanded) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 62 Sayı: 8
  • Basım Tarihi: 2020
  • Doi Numarası: 10.3139/120.111555
  • Dergi Adı: MATERIALS TESTING
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus, Compendex
  • Sayfa Sayıları: ss.793-802
  • Anahtar Kelimeler: Friction stir welding, pin profile, mechanical properties, microstructure, macrostructure, FATIGUE PROPERTIES, TENSILE-STRENGTH, ALUMINUM-ALLOY, PRECIPITATION, PARAMETERS, AA2024-T3, DEFORMATION, TEMPERATURE, BEHAVIOR
  • Yozgat Bozok Üniversitesi Adresli: Evet

Özet

In the present study, AA 2024-T351 plates with a thickness of 6 mm were joined using the friction stir welding technique with three different tool rotational speeds and two different pin profiles. Microstructural features and mechanical properties of welded joints were investigated. The grains in recrystallized regions along the stir zone were observed to be almost with invariable sizes. The grain size was revealed to increase with the increase in tool rotational speed. The average grain size was observed to dramatically increase from 2.3 mu m to 5.6 mu m for welded joints produced with pentagonal shaped pin. All the welded joints were observed to contain defects; the presence of defects exhibited a negative effect on the tensile properties of the welded joint. Most of the defects were observed to localize at the root region of joints. The joint, welded with the tool rotational speed of 250 rpm using pentagonal shaped pin, exhibited ultimate tensile strength with a value of 365 MPa. The ultimate tensile strength of welded joints was found to be higher with the decrease in the tool rotational speed. The welding efficiency of joints was compared with the ultimate tensile strength of base metal; notably, welding efficiency values between 46% and 80% were achieved. Microstructural characterizations revealed that Al2Cu (theta phase), Al2CuMg (S phase), and AlCuFeMnSi, Al7Cu2Fe intermetallic particles were dispersed in the stir zone.